Skip to main content

Sam Kear

  • Raspberry Pi Resources
  • pfSense Tutorials
  • FreeNAS Resources
  • Web Hosting
  • Amazon
  • About
  • Contact

Category: 3D Printing

Using PETG Filament With the Mendel90 Printer

February 17, 2018February 17, 2018 Sam Kear Leave a comment

PLA has been my favorite filament to use in my Mendel90 printer for many years.  It’s always been very easy to work with and has produced consistent results.  PLA sticks easily to a heated bed and yet releases without any effort once cooled. The main drawbacks to PLA are its low melting point and tendency […]

Read More

Recent Posts

  • Using a Custom SSL Certificate With UniFi SDN Controller
  • Connecting a Micro SD Card Adapter to the ESP8266 Development Board
  • Nest Temperature Sensor Review
  • Installation and Review of the Nest Hello Video Doorbell
  • ēdn SmallGarden 2 Indoor Garden System Review

Categories

  • 3D Printing
  • FreeNAS
  • Ham Radio
  • Hardware
  • Hosting
  • Linux
  • Misc
  • Networking
  • pfSense
  • Raspberry Pi
  • Security
  • Software
  • Windows
  • WordPress

Recent Comments

  • Rufus V. Smith on How to Control Power Outlets Wirelessly Using the Raspberry Pi
  • dj on Recovering a NeatWorks database
  • diego on How to compile iperf for Windows using Cygwin
  • Pam on Recovering a NeatWorks database
  • François Bégin on Using a Custom SSL Certificate With UniFi SDN Controller

Categories

  • Hardware
  • FreeNAS
  • Networking
Sam Kear Dot Com All rights reserved. Theme by Colorlib Powered by WordPress